Waterproof Coating
Polymer modified asphalt waterproof coating
PRODUCT OVERVIEW
This product is based on asphalt, polymer synthetic polymer as modifier, with a variety of complexing agent as auxiliary material, processed by special equipment. The utility model has the advantages of strong toughness, good elasticity, fatigue resistance, ageing resistance and excellent waterproof performance, etc. the utility model has the advantages of high temperature, no flow, low temperature and no brittle cracking, and cold construction, and has wide environmental adaptability.
Product features
●Cold construction, non-toxic, tasteless and pollution-free;
●It can be painted thickly and save labour time;
●The construction is safe and convenient, and can be constructed at the damp base, and has excellent cohesiveness to concrete, wood and asbestos board;
●The low temperature extension is excellent, which can well adapt to the deformation at the base and ensure the waterproof quality of the project;
●High temperature resistance, corrosion resistance, aging resistance.
Product use
This product is suitable for roofing, wall, toilet, bath room, basement, cold storage, bridge, railway subgrade, pool, underground pipe waterproof, impervious, moisture-proof, gas separation and other projects.
●All kinds of prefabricated, cast-in-place concrete structure of the plant,
●warehouses, civil buildings and other roofing and joint waterproof;
●The ground floor of the bottom residents is permanently damp proof, and the kitchen and water room and balcony are waterproof for a long time;
●Waterproof and impervious of basement wall, basement and pond;
●Repair the old asphalt roofing, asbestos tile roof and gutter, the water Water Leakage structure;
●The anticorrosion of the pipeline component can also be painted on the surface of the self - waterproof rigid component to prevent seepage and prevent the powder from corrosion.
Basic requirements
The quality of the base layer is directly related to the service life of the waterproof layer. Therefore, the grass roots must meet the following requirements:
●Cement mortar or concrete mark must comply with the design requirements;
●Basic to solid and flat without concave pits, no sand; surface drying, moisture content of<9%, no dirt, debris and oil etc..
●And the roof of the structure of the connection and the corner of the grassroots should be made of circular arc, its radius should not be less than 50mm;
●The section gap is aligned with the end seam of the panel, the width of the seam is 20mm;
●If the insulation layer, every 10-40 square meters to open a vent hole.
matters needing attention
●The base shall be maintained to a certain strength (not less than 0.3MPa) before construction;
●Paint must be fully stirred before use;
●Each of the construction must be dried in the coating after the construction can be carried out, the phenomenon of sticky feet, may be in advance to walk parts of water to overcome;
●The storage period of this product is nine months;
●This product is stored and shipped in accordance with non hazardous goods.
HOTLINE:400-651-9639
Fax:0086-(0)536-5078169
TEL:13665369397 0536-5078169
EMAIL:huaguangzdh@126.com
ADDRESS:6th Floor,Yuqing Building, 518# Yuquan Road, High-tech Development Zone, Weifang City, Shandong Province, P.R.China.
ALL RIGHTS RESERVED ©THE COPYRIGHT HUAGUANG WATERPROOF MATERIALS LIMITED BY SHARE LED.
ICP:鲁ICP备13030805号-1 TECHNICAL SUPPORT:QIHUA NETWORK